karena kesibukan MANUAL MASIH IN ENGLISH
Versi yang Rapi dan Bergambar KLIK DISINI
Thank you for purchasing GPS Tracker. This manual shows how to operate the device smoothly and
correctly. Make sure to read this manual carefully before using this product. Please note that
specification and information are subject to changes without prior notice in this manual. Any change
will be integrated in the latest release. The manufacturer assumes no responsibility for any errors or
omissions in this document.
1 Summary ———————————————————————————- 3
2 Application ——————————————————————————— 3
3 Hardware description
3.1 Front face ————————————————————————————– 3
3.2 Rear face ————————————————————————————– 3
3.3 Side face ————————————————————————————— 3
3.4 Bottom face ————————————————————————————— 4
3.5 Interior ————————————————————————————— 4
4 Specifications ————————————————————————————— 4
5.1 SIM card installation ———————————————————————– 5
5.2 Battery and Charger ———————————————————————— 5
5.3 Quick Startup ———————————————————————- 6
5.4 Initialization ———————————————————————- 6
5.5 Change the password —————————————————————- 6
5.6 Authorization ———————————————————————— 6
5.7 Real-time polling ———————————————————————— 7
5.8 Auto track ——————————————————————————– 8
5.9 Monitor Mode ———————————————————————— 8
5.10 Modes switch between “track” and “monitor” ————————— 8
5.11 Geo-fence ———————————————————————- 8
5.12 Movement Alert ———————————————————————– 9
5.13 Overspeed Alert ———————————————————————- 9
5.14 IMEI Check ———————————————————————- 10
5.15 SOS Button ——————————————————————– 10
5.16 Low battery alert ——————————————————————– 10
5.17 Hidden number tracking ——————————————————– 10
5.18 SMS center ——————————————————————– 10
5.19 GPRS setting ———————————————————————- 11
6 Cautions ——————————————————————— 13
7 Faults & Solutions ——————————————————————— 13
Working based on existing GSM/GPRS network and GPS satellites, this product can
locate and monitor any remote targets by SMS or GPRS.
Rental vehicle / Fleet management etc
Protect the child / the old / the disabled / pet etc
3 Hardware Description
3.1 Front face 3.2 Rear face
3.3 Side face
You can update software,
charge battery from here.
You can press the “SOS” buttons for 3s for
Indicator for signals.
Turn on / off the unit here.
3.4 Bottom face
Dimension. 64mm x 46mm x 17mm(1.8”*2.5”*0.65”)
Band 850/900/1800/1900Mhz or 900/1800/1900Mhz
GPS chip SIRF3 chip
GPS sensitivity -159dBm
GPS accuracy 5m
Time To First Fix
Cold status 45s
Warm status 35s
Hot status 1s
Car charger 12—24V input
Wall charger 110?220V input
Battery Chargeable changeable 3.7V 800mAh Li-ion battery
Storage Temp. -40°C to +85°C
Operation Temp. -20°C to +55°C
Humidity 5%–95% non-condensing
Install the battery like this.
GSM/GPRS antenna is inside Microphone
Put SIM card here.
5.1 SIM card installation
Make sure that there is no call transfer and call display is on, and PIN code off. The
SMS message must in Text format, can’t be identified for PDU format.
1 Open the rear cover, and pick out the battery.
2 Push the foil along and turn it left.
3 Put the SIM card into the holder, and turn the foil right and fasten it in place.
5.2 Battery and Charger
Do charge the battery to capacity in 8 -12 hours for first use. Please use the battery and
charger provided by the manufacturer. This unit adopts built-in Li-ion battery, and full
battery will support around 48 hours use on end. After first use, the battery can be
charged fully in 3-5hours.
a: For it’s Li-ion battery, which contains harmful chemicals and may burst, please don’t bump,
puncture it violently and keep it off fire.
b: Please charge the battery in time to keep it working normally.
Put the SIM card and battery in place.
The unit turns on automatically when the sim card and battery is inserted.
For first use, please initialize the unit and restore it to default setting.( please refer to
5.4 for instruction.)
In 10 or 40 seconds, the unit will begin to work and acquire the GSM signals as well
as the GPS signals. The indicator will keep flashing every 4 seconds when the unit
has received the signals, otherwise it will keep on.
When this unit receives GPS signals normally, you can use it and do all the following
Send “begin+password” in SMS to the unit, it will reply “begin ok” and initialize all the
settings. (default password: 123456)
5.5 Change the Password
Send SMS password+old password+space+new password to change the password.
5.5.1 Be sure keep the new password in mind, you have to upload the software to
restore the original setting in case of losing the new password.
5.5.2 Make sure the new password is in 6 digits, or else the tracker can not recognize
There are only 5 numbers able to be authorized.
5.6.1 Setup: Call the tracker for 10 times, it will make the cell phone number as the
authorized number automatically.
5.6.2 Setup: Send SMS admin+password+space+cell phone number to set up a
authorized number. The other authorized numbers should be set by the first
authorized number. If the number is successfully authorized, the unit will reply “admin
ok!” in SMS.
5.6.3 Cancel: Send SMS noadmin+password+space+authorized number to delete the
5.6.4 For roaming purpose, you have to add your country code ahead of the cell phone
number, for example, please send admin123456 008613322221111 to tracker to set
13322221111 as an authorized number.
5.7 Real-time Polling
5.7.1 If there is no authorized number, when any number dials up the unit, it will report a
Geo-info; If there is already an authorized number, then it will not respond when an
unauthorized number calls it up.
5.7.2 When an authorized number dials up the unit, it will hang up and report a real-time
Geo-info as below:
Report a Geo-info at 30s intervals to the authorized numbers for 5 times:
5.8.1 Setup: Send SMS t030s005n+password to the unit, it will report the Geo-info at
30s intervals for 5 times.(s: second, m: minute, h: hour). The setting must be in 3 digits
and at maximum 255 in value.
5.8.2 Send SMS t030s***n+password to the unit, it will reply SMS heaps of times
5.8.3 Cancel: Send notn+password to delete the “ auto track ”
Remark: the interval must not be less than 20s.
5.9 Monitoering Mode(Voice Surveillance)
In this mode, the user can dial up the unit to hear the voice around the tracker after your
call.(please refer to 5.10 for instruction).
5.10 Modes switch between “track” and “monitor”
5.10.1. The default mode is “track”.
5.10.2. Send SMS monitor+password to the unit, and it will reply “monitor ok!” and
switch to “monitor”mode.
5.10.3. Send SMS tracker+password to the unit, it will reply “tracker ok!” and restore to
Set up a geo-fence for the unit to restrict its movements within a district. The unit will
send the message to the authorized numbers when it breaches the district.
5.11.1 Setup: When the unit stays immobile in a place for 3-10 minutes, the user can
Send SMS stockade+password+space+latitude,longitude; latitude,longitude to unit to
set the restricted district. In case of breach, it will send SMS “stockade!+geo-info” to the
Remark: The first latitude&longitude is coordinate of the top left corner of the
Geo-fence, while the second latitude&longitude is the coordinate of the bottom right
corner. It will alarm one time in each setting.
5.11.2 Cancel: Send SMS nostockade+password to deactivate this function.
This function will be out of effect after the unit moves outside the district.
5.12 Movement Alert
5.12.1 Setup: When the unit stays immobile in a place for 3-10 minutes, the user can
send SMS move+password to the unit, then the unit will reply “move ok!”. In case of
such a movement, it will send SMS “Move” along with a Geo-info to the authorized
numbers. It will alarm one time in each setting.
5.12.2 Cancel: Send SMS nomove+password to deactivate the movement alert.
Remark: This function will be out of effect after the unit moves outside the district.
5.13 Overspeed Alert:
5.13.1 Setup: Send SMS speed+password+space+080 to the unit (suppose the speed
is 80km/h), and it will reply “speed ok!”. When the target moves exceeding 80 km/h, the
unit will send SMS speed+080!+Geo-info to the authorized numbers. It will alarm one
time in each setting.
5.13.2 Cancel: Send SMS nospeed+password to deactivate the overspeed alert
Remark: It is recommended that the speed alarm is set at not less than 50km/h. For
below that rate, it may cause the excursion of the GPS signal influenced by clounds etc.
Response SMS format: speed+080!+Geo-info (suppose the speed is 80km/h).
The tracker will check the speed in 10 minutes interval and alarm if it is overspeed.
5.14 IMEI Checking:
Send SMS imei+password to the unit to check the IMEI number of the tracker.
5.15 SOS Button
Press the SOS for 3 second, it will send “ help me !+ Geo-info” to all the authorized
numbers every 3 minutes. It will stop sending such a SMS when any authorized number
reply SMS ”help me!” to the tracker.
5.16 Low battery Alert
It begins to send SMS to the user every 30minutes when the the battery voltage is 3.7V.
SMS format: low battery+Geo-info.
5.17 Hidden Number Tracking
When a hidden authorized number calls the tracker, the tracker will reply SMS with the
hidden number&Geo-info to all the authorized numbers.
5.17.1 Send SMS “hide number” to set up the hidden number.
5.17.2 Send SMS “nohide number” to delete the hidden number.
5.18 SMS Center
5.18.1 Setup: Send SMS adminsms+password+space+cell phone number to set the
If the SMS center is set up, when an authorized number sends SMS to the tracker, the
tracker will reply a SMS with Geo-info & authorized number to SMS center.
5.18.2 Cancel: Send SMS noadminsms+password to cancel the SMS center.
Response SMS format: authorized number+Geo-info
5.19 GPRS Setting
In order to use GPRS function, the user needs to set IP, Port and APN ( access point
name ) by either cell phone, or our PC software.
? NOTE: Some countries or regions should set APN’s User Name and APN’s
5.19.1 Set an IP address and port:
Setup: Send SMS adminip+123456+space+IP address+space+port.
If setup successful, the tracker will reply SMS “adminip ok”
Cancel: Send SMS noadminip+123456
5.19.2 Set APN
Setup: Send SMS apn+123456+space+specify apn content.
If setup successful, the tracker will reply SMS “APN ok”.
Cancel: The old APN will be invalid automatically when a new APN is set.
5.19.3 Set APN’s User Name
Setup: Send SMS apnuser+123456+space+the sim card’s user name.
If setup successful, the tracker will reply SMS “apnuser ok”.
Cancel: The old APN user name will be invalid automatically when a new APN uer
name is set.
5.19.4 Set APN’s Password
Setup: Send SMS apnpasswd+123456+space+the sim card’s password.
If setup successful, the tracker will reply SMS “apnpasswrod ok”.
Cancel: The old APN password will be invalid automatically when a new APN password
5.19.5 GPRS transport protocols
As soon as the IP & Port & APN are set up, the user can make a call or send SMS to
tracker. The tracker will hand up and report the coordinates to IP address.
The message format sent by tracker to IP address is as following:
Serial number + authorized number + GPRMC + GPS signal indicator + command +
IMEI number + CRC16 checksum.
For example, it will send GPS coordinates as below illustrated
?Our gprs supports TCP or UDP protocol, so please confirm whether your GPRS
webserver supports TCP or UDP protocol before having the order.
? Please use the SIM card which is with GPRS function.
? Pls use the following SMS to set up GMT time in the SMS for the tracker
time zone+password+space+ the customer’s GMT TIME
? Pls use the following SMS to set up YOUR website in the SMS for the tracker
home+password+space+ the customer’s WEBSITE
home+password+space+space (if there is no website in the SMS)
Please comply with the instructions to extend the unit life:
1. Keep the unit dry. Any liquid, i.e. rain, moisture, may destroy or damage the inside
2. Don’t use & store the unit in dusty places.
3. Don’t put the unit in overheated or overcooled places.
4. Handle carefully. Don’t vibrate or shake it violently.
5. Clear the unit with a piece of dry cloth. Don’t clean in chemicals, detergent.
6. Don’t paint the unit, this may cause some foreign materials left in between the parts.
7. Don’t disassemble or refit the unit.
8. Please use the battery and charger provided by manufacturer. Using other batteries
and chargers will cause unwanted situation.
9. Don’t dismount the antenna randomly, or use other antennas. This may interfere the
transmission, and increase the radiation as well.
7 Faults & The solutions
Startup Fail Check the battery and see if it is fully charged or
Hangup Fail In existence of an authorized number, an unauthorized
number dials up the unit. Please initialize the unit and re-set
up the authorized numbers.
Check if the authorized number is setup or in the coverage
Location report in
digits of zeros.
Don’t use it in the place beyond reach of signals. Place the
unit outdoors, especially when starting it up.